Ericsson EDACS MDX Betreibershandbuch PDF herunterladen (Seite 11)

viewed/edited by returning to the main screen by pressing F10 Back, and

pressing F4 Freq.

Upon pressing F4 Tx On, the programmer will put the radio into

transmit mode. The screen will display a blinking field, "TRANSMITTER

ON", to indicate that the radio is transmitting. The radio will remain in

transmit mode until F4 Tx Off is pressed, or the timeout period (about 2

minutes) has been exceeded. If the timeout period is exceeded, the screen

will display a blinking field, "TRANSMITTER TIMEOUT", for a short

period of time and the transmitter will be turned off.

In addition to entering a value from the keyboard, there are key

actions available as described below:

<+> Increments the field by 1 and writes the new value to the radio

if the transmitter is on.

<-> Same as <+> only it decrements.

↑↓→← Arrow keys move the cursor between fields on the screen.

From Figure 3:

(1) This is a numeric field that is used to align the transmit high and low

power levels. This field will accept any hex value from 00-FF and

any decimal value from 0 - 255, depending on the current state of the

screen (Hexadecimal or decimal) displays. The bar indicator changes

with and provides a direct representation of the value of this field.

(2) This field is a display only field and indicates the minimum value that

can be selected.

(3) This field is a display only field and indicates the maximum value

that can be selected.

LBI-38898

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Keine Kommentare

Ericsson EDACS MDX Betreibershandbuch Seite 11