Ericsson W25 Betriebsanweisung PDF herunterladen (Seite 60)

PC Configuration

54 5/1551-CRH 102 167 Uen Rev C 2007-04-25

PC. The driver files and instructions on how to install them are provided

together with the interface.

5.2.3 Configuring PC Access to the Ericsson W25

The configuration steps below will vary depending on both the operating

system and the Wireless LAN interface installed on the PC. These steps

provide a basic outline. For specific instructions, refer to the documentation

provided with your Wireless LAN interface.

Configure the following wireless parameters on each of the wireless PCs:

− Set the Wireless LAN interface to use infrastructure mode. This

configures the PCs to access each other and the Internet through

the Ericsson W25.

− Configure the network name (SSID) and channel to match the

network name and channel configured on the Ericsson W25. This

information can usually be obtained through WLAN scanning. The

network name is case sensitive.

− If you are using Wired Equivalent Privacy (WEP) security,

configure the same encryption key that is configured on the

Ericsson W25.

− If you are using Wi-Fi Protected Access (WPA or WPA2) security,

configure the same passphrase that is configured on the Ericsson

W25. The passphrase is case sensitive.

Note: Computers running Windows 2000

does not support WPA

or WPA2 encryption.

− Configure the IP settings using the procedure described in section

5.1– “IP Settings”.

5.3 Sharing Settings

When a shared device is connected to the Ericsson W25, information about

the device is displayed on the Sharing page. To be able to use the shared

device you also have to set up a connection to the shared device on your

PC.

In some cases, you have to make sure that your PC belongs to the same

workgroup as the Ericsson W25. Follow the instructions in section

5.3.1 –

“Checking Workgroup Settings” to check the workgroup on your PC.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 87 88

Keine Kommentare

Ericsson W25 Betriebsanweisung Seite 60