Ericsson HM220d Betriebsanweisung PDF herunterladen (Seite 11)

Installation using Ethernet (for Windows 95 or higher PCs)

EN/LZT1083982 R4 11 (87)

2000-12-07

2.2 Connecting equipment

To connect your HM220d ADSL modem via the Ethernet interface, follow these steps:

1 Connect one end of the Telephone/ADSL cable to the modem's ADSL port and the

other end to the ADSL service port (wall jack or splitter/filter).

2 Connect one end of the Ethernet cable to the ETHERNET port on the back of the

modem and connect the other end to the Ethernet 10Base-T network card on your

computer.

3 Connect the Power cable to the POWER connector on the back of the modem. Plug

the power supply adapter into a power source.

Figur 1: Connect via Ethernet interface

Assuming the modem has been connected properly, the modem will enter the power-up

diagnostics state and verify the integrity of the hardware and software. Please refer to

chapter 6.3 Operational states, for further information. When this happens all of the LEDs

(light-emitting diodes) on top of the modem will turn ON briefly.

When the Power, Ethernet and ADSL LEDs have turned solid yellow, the modem is

ready for operation.

Figur 2: LED symbols for Power, Ethernet and ADSL

If not, check that the cables have been securely connected to both the modem, PC, ADSL

service port and power source.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 86 87

Keine Kommentare

Ericsson HM220d Betriebsanweisung Seite 11