Ericsson LBI-39001 Bedienungsanleitung PDF herunterladen (Seite 11)

INITIAL SETUP LBI-39040

Table 1 - Application Loading (Cont.)

Type of Loading Application Expected Results

8. The PI terminal will

indicate the copy of the

following file to the PI hard

drive:

JESS_B.SX

9. At the prompt for the next

disk, remove Jessica Disk

3 and press "Enter".

10. Proceed to Table 2. On an

upgrade, begin with Step 3

of Table 2.

Application loading from hard

drive

(Requires Jessica software to

have been previously

installed)

1. Engage Jessica system

power.

1. The PIC, PRI-48/-64 ISDN board, and

the MIC are booted.

2. "Login" is displayed.

3.5. CONFIGURATION FILE LOADING

This section describes the installation of the Jessica configuration from either a floppy disk or a hard drive.

The Jessica configuration file may specify:

• Site ID

• Hang Time (used for half-duplex interconnect calls)

• Conversation Time Limit (used for all interconnect calls)

• Trunk Type (T1 or E1)

• Mask of Available MUX Audio Channels

If a configuration parameter is not specified, its default value will be used during system operation. Refer to section 4 for

default configuration parameters.

Steps 1 and 2 of the Procedure section in Table 2 should be performed on a PC with a text editor. CONFIG.DAT may be

edited remotely using NFS mounted directories.

NOTE

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 95 96

Keine Kommentare

Ericsson LBI-39001 Bedienungsanleitung Seite 11