AE/LZB 119 1890 R1A
15
8. Press again and observe that display reads
PROGRAM.
9. Set the SERVICE switch on Troubleshoot Box to the
5V position.
Do not set SERVICE switch to the 12V position
when using the Troubleshoot Box with the IPE
Series radios.
CAUTION
10. Program the radio as indicated in the PC Programming
Software.
Observe Free Space Calculation for IPE radio.
NOTE
FLASH PROGRAMMING
The "FLASH" software is the current version of the IPE
operating software. Upgrades to the Operating Software can
be flashed to the radio.
The FLASH software is loaded into the radio using a
Personal Computer, the TEK Box (item 2 from the
equipment list) and the TEK Utility Software.
TEK Box And Utility Software
Installation
1. Insert the TEK software disk into the floppy disk drive
on the computer (item 6 on the equipment list).
2. Type "X:" <<enter>> , where "X" is the letter of the
disk drive.
3. Type "Install" <<enter >>.
4. The program will attempt to install the executable to the
C:\TEK directory. If the directory does not exist the
program will prompt to create the directory. Type "Y"
<<enter>>. The program will copy the executable.
Equipment Setup
For downloading the Flash software file, setup the items
required from the equipment list as shown in Figure 13.
Remove battery from radio before any connections.
NOTE
Starting The Program
The TEK Utility Software will not run while in Windows.
Type "Flasher" to start the program. The Software
Download Screen will appear as shown in Figure 11.
Figure 11 - Software Download
Changing Drives/Path
Press F2 - Choose Drive to select another drive or F3 -
Enter Path to change the path of the current drive. When
downloading a Flash file to the radio, these function keys are
used to select the proper drive and path where the Flash file
is located.
Figure 12 - Change Drive
Port Selection
Select F4 - Port Selection to define COMM port parameters
for downloading files. The screen in Figure 14 will appear.
Change the port selected by pressing "A" until the
desired selection is displayed. Be sure the COMM port
selected here matches the physical COMM port the
programming cable is connected to on the computer.
Change the baud rate by pressing "F" until the desired
baud rate is displayed. The maximum bit rate should be
set to 9600 bps.
It is usually not required to change COMM port
hardware settings. But if a problem is suspected, press
"G" to change the setup. Refer to the computer manual
for proper settings.
NOTE
(22 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern