Ericsson RX1290 Betriebsanweisung PDF herunterladen (Seite 45)

Operating the Equipment Locally

Reference Guide: RX1290 H.264 Contribution Receiver

Page 3-9

ST.RE.E10228.1

3.6.3 10/100BaseT IP

Table 3.8 steps through the set up procedure of the Telco Receiver using

Menu 2 Input, and the IP input.

Table 3.8: Setting Up the IP Interface

Step Action Result

1 Connect the Ethernet cable to the IP input

connector.

2 Power up the unit and navigate to Menu 2

Input.

Accesses the Input menu.

3 Navigate to UDP PORT (Menu 2.3.2), then

press Edit.

Select the Receive UDP Port number, then

press Save.

Edits the UDP Port parameter.

4 Navigate to IP INPUT IP ADDRESS (Menu

2.3.2.1), then press Edit.

Select the IP address, then press Save.

Edits the IP Input address parameter.

5 Navigate to IP INPUT SUBNET MASK (Menu

2.3.2.2), then press Edit.

Select the Subnet mask, then press Save.

Edits the IP Input subnet mask parameter.

6 Navigate to IP INPUT GATEWAY ADDRESS

(Menu 2.3.2.3), then press Edit.

Select the Gateway address, then press Save.

Edits the IP Input Gateway address parameter.

7 Navigate to IP INPUT MULTICAST IP ADD

(Menu 2.3.2.4), then press Edit.

Select the Multicast IP address, then press

Save.

Edits the IP Input Multicast IP address parameter.

8 Return to Input Menu 2, it should display the

current status. If status is NOT LOCKED,

verify that the cable is properly connected and

that all values have been entered correctly.

3.7 Service Configuration (Menu 3)

3.7.1 Selecting and Setting Up a Service

Each Transport Stream may contain many Services. Menu 3 allows a Service to be chosen as

current and the profile of its components to be specified. This Service will be used as the

power-up default Service until a new Service is selected.

Table 3.9: Selecting a Service

Step Action Result

1 Go to Menu 3 and select the required Service.

The Edit mode cannot be entered unless

there are available Services.

This page shows the total number of Services available in the

incoming Transport Stream. Use Edit and the arrow

pushbuttons to select the required Service.

2 Press Save. This stores the Service as the Current Service.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 135 136

Kommentare zu diesen Handbüchern

Keine Kommentare

Ericsson RX1290 Betriebsanweisung Seite 45

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Empfänger Ericsson RX1290